Hi Massimo, I connect the wires to the numbers as in the picture below. Is it ok?Just an update: i installed the led that illuminates under the cover area just like the GT
There was coding involved in the 09 central electric control unit….
View attachment 235535View attachment 235534View attachment 235536View attachment 235537View attachment 235538View attachment 235539
Yes correct.Hi Massimo, I connect the wires to the numbers as in the picture below. Is it ok?
" Interior_light_lin_slaves_config: Lin9_slave_7: from not installed to installed."The Led Part is 5H0947145C and Connector is 8K0973754. You will need cabling.
For coding in 09:
Interior_light_router_config: Output_lin9_light_function_slave_7: from 0 to 12
Interior_light_lin_slaves_config: Lin9_slave_7: from not installed to installed.
I got few questions for youJust an update: i installed the led that illuminates under the cover area just like the GT
There was coding involved in the 09 central electric control unit….
View attachment 235535View attachment 235534View attachment 235536View attachment 235537View attachment 235538View attachment 235539
Update: ordered the part from LLLParts and received the correct one...thank God
Use a hardened plastic tool remover like in the photo.
So remove the Usb trim(1) and then the Dsg trim (2) on the right and then the one on the left(3) (they are clipped in) and mount the cover with 3x3.5mm 16-17mm length screws ( I used screws used for the plug outlets )] ( You need to take extra care with the left side trim on removal and installing it.. don't force anything and study it well when reinstalling it as not to break the clip inserts)
Better solution would be to remove the whole center consolle which makes it a lot easier to work...
So now I have a GT consolle with the cover and dsg gear stick with heartbeat effect and red light..
I am trying to remove the trim (3), which tools do I need, is there anywhere I can find where the clips are so I don't mess it up while removing part 1,2 and 3 of your picture? Thank you.Update: ordered the part from LLLParts and received the correct one...thank God
Use a hardened plastic tool remover like in the photo.
So remove the Usb trim(1) and then the Dsg trim (2) on the right and then the one on the left(3) (they are clipped in) and mount the cover with 3x3.5mm 16-17mm length screws ( I used screws used for the plug outlets )] ( You need to take extra care with the left side trim on removal and installing it.. don't force anything and study it well when reinstalling it as not to break the clip inserts)
Better solution would be to remove the whole center consolle which makes it a lot easier to work...
So now I have a GT consolle with the cover and dsg gear stick with heartbeat effect and red light..