Goodbar's latest activity

Rear main 06H103171A Front main 06L103085B Valve cover sealant- ELR-509860 Spool valve seal - ELR-302690 Timing cover gasket- 268000...

I just read this entire thread at work. This should be the plot for F&F11. I laughed, I cried, it kept me on the edge of my seat...

poor guy! Well time will tell if the engines are any good though so there’s always that risk involved I’ll keep pushing this engine...

Asking about the recommended break in procedure…..so, full send? 😆

I threaded the rod into the WG linkage to hold it in place. Still a little fiddly to get it lined up, but didn't require a second person.

Got this job finished. I unbolted the driveshaft and downpipe and moved them aside to get access to the actuator from below. The oil...

Struggling to get the wastegate actuator off my IS12 on my 4Motion car. I was able to remove the T30 bolt closer to the engine, but the...

Yup, either bad actuator or corrosion.

I have the same car (GSW 4Motion, 6MT, though 2019) and same tune (APR Stage 1, 87 AKI, no bolt-ons, original turbo) and got the same...

In the end I have done the option 2. So 55mm alu knuckle from gti/gtd golf 7 and first bilstein b4 and then year later bilstein b8...

Well, that wasn't the whole thread. They didn't seem bothered that a customer had trouble installing their parts. At the very least they...

I was in a bind and needed the car the next day, so I shaved them down a bit with a strip disc. Obviously not ideal. But they seem to be...