3D Printer & C.A.D. Thread

[NoGodGetOverIt]

You get your sonic pad set up?

Ran into a bump in the road in the form of a lost MicroSD-USB converter, so I couldn't run the updates. Replacement arrives today.

The worst part is that, because I couldn't complete the setup, everything I'd done up to that point (including wireless config) was toast when the system slept.

Also, I don't have the CR Touch module, so I guess I'll have to print out the bracket for the calibration sensor.

 

[Corprin]

Roku remote is a design I got off thingiverse. The TV remote is something I did on TinkerCad over lunch.

 

[dtfd]

Pretty colour. What filament is that?

 

[Corprin]

Pretty colour. What filament is that?

eSun PLA silk blue/green

 

[dtfd]

Picked up some Inland (Micro Center/eSun) PLA+ today.

Calibration cube came out ab-so-lutely perfect, right out of the bag.

Temp: 210
Bed: 60
Speed: 50mm/sec
Fan: 100%

 

[GolNat]

Picked up some Inland (Micro Center/eSun) PLA+ today.

Calibration cube came out ab-so-lutely perfect, right out of the bag.

Temp: 210
Bed: 60
Speed: 50mm/sec
Fan: 100%

I have been considering PLA+ over PETG. Glad to hear it came out nice.

I’d really like to try some flexable filament but I have read it can be difficult with a Bowden setup

 

[Corprin]

Little brackets and some t-nuts printed to mount the sonic pad to the printer.

 

[Corprin]

https://www.amazon.com/Logitech-Laptop-Webcam-Design-360-Degree/dp/B004YW7WCY

Picked up one of these webcams for pictures. Now need to figure out where to mount it.

It’s a hike down to the basement to check on print status, this lets me look without a walk. Right now I get a status of what it should be, but reality can differ.

(Wall mount for OLED Nintendo Switch and 7 game cards)

 

[GolNat]

Made some Thingiverse stuff for the printer

Waiting on some PETG to arrive and my wifi chip.

I like that camera. The baby cam I’m using is kinda big and I was gonna make a mount for it as a nice little project for practice but it would be better to get a different camera first.

 

[GolNat]

Ordered some TPU to try. I would like to use it on a bib holder that I made but if it’s too much of a pain I’ll just use PLA.
Need to round the corners, maybe add his name.

 

[Corprin]

Wall mounts for Nintendo switch pro wireless controllers. Found on thingiverse, but the were a bit narrow. So I did a bit of modding in tinkercad by widening them by 15mm so the controller self centers.

 

[GolNat]

Such a nice big build plate

 

[NoGodGetOverIt]

Such a nice big build plate

Yeah, no kidding! I have plate envy.

 

[Corprin]

Such a nice big build plate

I was a little unsure if going with the Ender 5 S1 was too much for a first printer, but glad I did.

 

[AzteCypher]

Printing these little dinos for my daughter's upcoming birthday party. The rest are just stuff I found useful or fun. Now I wish I had gone with the Ender 5 though. I may peruse the used market and buy a fixer upper that I can mod.

Narrow nozzle for my Shopvac

Mk7 Golf cell phone holder

Brace to keep Atari circuit board in place

Tuna can ashtray