I designed and printed wheel markers for my second set of wheels

[gixxerfool]

Partly because I could and partly because I’m mentally defective.

Prior I would use tire chalk, that worked fine then I ran out. Then I used tape and marker, that didn’t work as well. It would have the tendency to fall off and wasn’t reusable.

So I did what any sane and rational person would, design and print reusable markers. Place them in the position where they came off and they can get rotated to new positions when put back on.

A couple of layers of Tesa tape to give it the perfect friction fit and not scratch the lug holes in the wheels.

That is all. Welcome to my brain.

 

[GolNat]

Nice!

We have a 3D printer thread if you did not know.
https://www.golfmk6.com/forums/index.php?threads/3d-printer-c-a-d-thread.413413/

 

[dtfd]

Nice! Did you upload the STL anywhere

 

[gixxerfool]

Nice!

We have a 3D printer thread if you did not know.
https://www.golfmk6.com/forums/index.php?threads/3d-printer-c-a-d-thread.413413/

Thanks. I didn’t. I’ll pop in there and check it out.

Nice! Did you upload the STL anywhere

I didn’t. I can. I’ll do it later when I get home. Anything better than Thingiverse?

 

[MonkeyMD]

I guess better than my solution of permanent marker numbers 1-4 on inside of wheel & keep track of which wheel was where by number

 

[dtfd]

Thanks. I didn’t. I’ll pop in there and check it out.

I didn’t. I can. I’ll do it later when I get home. Anything better than Thingiverse?

That's where I grab most of mine.

 

[gixxerfool]

I guess better than my solution of permanent marker numbers 1-4 on inside of wheel & keep track of which wheel was where by number

That works too.

 

[gixxerfool]

That's where I grab most of mine.

I’ll post it there and let you know. I’ve never done it as I don’t usually share my STLs.

 

[gixxerfool]

That's where I grab most of mine.

https://www.thingiverse.com/thing:6105667/files

Here you go.