worldacgti
Go Kart Champion
Are you scanning while the engine is running? Mine did that too. Don't scan with engine running.....just with the accesories on....bet you those codes disappear
Are you scanning while the engine is running? Mine did that too. Don't scan with engine running.....just with the accesories on....bet you those codes disappear
Interesting you mentioned the "Error: Service Vehicle. Only leave vehicle in P position!" error, I get it once in a while but since it goes away immediately I never think much about it. Did you have to show the dealer your VCDS code or did they see it themselves when they checked?
there is a pretty big thread about it on here... i would recommend having your dealer check it out...
New shifter is a bit sticky and I have to push it back up into D from S rather than it springing back on its own, but the dealer asked me to drive it for a couple of weeks to see if it wears in on its own. It does function fine, just not quite right, so I may be returning to have a new part installed.
Nicely done! I'm glad to have been helpful.